Leave Your Message
Products Categories
Featured Products

ABB Assembly Robots

ABB built its reputation on motion control. The IRC5 and OmniCore controllers run TrueMove and QuickMove, which keep the path accurate when the arm is moving fast, and RobotStudio lets you simulate the cycle before you cut metal. In the used market this matters for a simple reason: the controller generation decides what options you can add later, so check whether the unit is IRC5 or OmniCore before you plan the integration.

Assembly work is decided by three numbers: the payload at the tool flange including the gripper, the repeatability your joint tolerance allows, and the cycle time the line demands. A small arm with good repeatability usually beats a large arm running slow, because assembly errors come from positioning, not from strength. Tell us the part, the fixture height and the required cycle, and we narrow it to the arms that actually fit rather than the ones on a spec sheet.

Send us the part, the required cycle and the controller you plan to run. We will confirm which ABB units fit and what condition they are in - no stock list, no guessed lead time.